All balls polos drive yamaha viking 700 14 18

ALLBALLS DRIVE SHAFT

AB8-YA-8-355

REAR LEFT/RIGHT SIDE Manufacturer: ALL BALLS

APPLICATION :

REAR SHAFT LEFT YAMAHA VIKING 700 14-18, VIKING 700 EPS 18, VIKING 700 EPS RED/GREEN 18, VIKING 700 VI EPS 15-18, VIKING 700 VI EPS HUNTER 18, VIKING 700 VI EPS RANCH 18, WOLVERINE 17, WOLVERINE E PS 17, WOLVERINE R-SPEC EPS 16-17,

REAR HALF SHAFT RIGHT YAMAHA VIKING 700 14-18, VIKING 700 EPS 18, VIKING 700 EPS RED/GREEN 18, VIKING 700 VI EPS 15-18, VIKING 700 VI EPS HUNTER 18, VIKING 700 VI EPS RANCH 18, WOLVERINE 17, WOLVERINE E PS 17, WOLVERINE R-SPEC EPS 16-17

OEM Basic Line

corresponds to the parameters and durability of OEM axle shafts. Their workmanship is at the highest level, so we can successfully replace worn-out OEM axles with these half-axles.

6Ball Heavy Duty Axle line

this is a higher shelf, and the durability of these products exceeds OEM products, and outperforms all competitors in "fatigue" and torsion tests by 30%. The 6Ball series axle shafts are equipped with 6 precision-made ball bearings of increased dimensions, the axle is laminated, which protects it very effectively against corrosion

8Ball Extreme Duty Axle line

is intended for the most demanding users who are not afraid of the most difficult terrain conditions. The 8Ball axle shaft is equipped with an 8-ball precision bearing, the dimensions of the basket and raceway are increased by 35% compared to OEM products, thanks to which their durability compared to competitive brand products is much higher. Thanks to the 8 ball bearings used, the joint is no longer the weakest link in the axle shaft, and a quad equipped with this type of axle shafts will certainly survive in the most difficult terrain for a longer period of time

To sum up, All Balls has introduced a product to the market that is distinguished by higher durability compared to the competition and exceeds the quality of factory products.

As a result of the tests carried out, it is certainly possible state that All Balls reinforced axle shafts are:

- 30% stronger than the competition,

- much stronger than OEM axle shafts,

- laminated, making them resistant to corrosion,

- precisely made, so their installation is not a problem,

- equipped with 6 and 8 ball enlarged bearings, thanks to which the joints are much stronger,

- production is carried out in accordance with ISO 9001 standards and requirements, thanks to which product quality control is at the highest level.

We have a product that will work in the most difficult conditions and will allow us to forget about the problem of spinning axle shafts for a long time.