Polcover 5-layer strong camper cover

POLCOVER camper cover COVER SIZE:

Cover made to order for the given dimensions of the camper, measured according to the diagram

COVER FEATURES

Camper cover of Polish production.

Made of high-quality, thick materials resistant to weather conditions.

The cover material is equipped with with a UV filter protecting the material from the sun.

Soft on the inside, safe for the camper body.

Waterproof material containing foil on the entire upper part of the cover protects the trailer against precipitation.

Breathable material with micropores on the side parts of the cover allows air circulation under the cover .

SOLID MOUNTING

The cover is attached with a belt around the camper.

It prevents the cover from being torn off the camper and ensures proper positioning of the cover. The fastening belt used in the cover runs through wide, strong eyelets. They will not wear out quickly like tunnels with string, and the belt included in the set will allow you to firmly pull the cover under the door sills. The fastening belt is finished with a buckle with a tensioner, which facilitates installation.

Additionally, the cover has two wide fastening belts placed under the body, which also fasten the cover in height.

STRAPES ON THE FRONT OF THE COVER

Two horizontal belts are sewn into the front of the cover. After tightening them, the cover is tightened and fits perfectly to the shape of the camper. This not only ensures aesthetics, but above all limits the movement of the cover in the wind.

TWO ZIPPERS FROM THE ENTRANCE SIDE OF THE CAMERA:

allow entry to the camper,

covered from the inside and outside,

trimmed,

frost-resistant,

a clasp at the bottom to prevent the zipper from being undone.

The zippers are located on the right side (passenger's side).

Campavan protection:

IN WINTER - against frost, ice and snow,

IN SPRING - against pollen, resin and tree sap, dust, sand , rain and wind, against bird droppings

IN SUMMER - against UV radiation,

IN AUTUMN - against falling leaves, cones, rain and wind

POSSIBILITY OF MADE TO MEASURE

The cover is made to suit the dimensions of the camper given by the customer. Measure the camper according to the diagram below and provide these dimensions when ordering and send us a photo of the camper.

Diagram No. 1 - dimensions of a semi-integrated camper

Diagram No. 2 - dimensions of a camper with an alcove.

IMPORTANT NOTES

Dimension S1 (length at the bottom from the profile) must be the maximum dimension, including the trunk/lamps/bumpers, etc.

Dimension D (width) must include the awning over the window if it is installed.

Dimension H (height) is the height of the structure itself (not to the ground), possibly with railings (we, when making cover, we add an allowance for the antenna/air conditioning, etc.)

Dimension S2 (length at the top) is measured approximately 20 cm below the top edge to ignore rounding.