Strong wires, jumper cables 1000a 4 5m 12 24v

Jumper cables 12/24V 4.5 m 1000A with cover SKRAW-MET CODE: [3056] Jumper cables are designed to support starting a vehicle with a discharged battery using electricity taken from the battery of another vehicle.

Very useful in the basic equipment of a car - especially in winter, in which low temperatures make it easier for a discharged battery to occur. A bundle with a thick weave made of the highest quality copper-plated wires. Copper-plated clamps, which ensures:

very good current flow,

effective and quick engine start,

no overheating of the wires

efficiency at extremely low temperatures

Technical specifications: Maximum current: 1000 A

Cable length with clamps: 4.5 m

Diameter cable: 22 mm

Length of clamps: 160 mm

Stroke of clamp clamp: 100 mm

Resistant to very low and high temperatures: -70°C to +160°C

Material: Wires: copper-plated

Clamps: copper-plated

Strong clamps insulated on handles will enable the safe use of cables in the most difficult conditions.

Cables are packed in a practical cover that protects against dirt. On the other side of the cover there is an instruction manual, making it easier to start a disabled car with a discharged battery.

At our other auctions you will also find cables of other lengths and maximum currents. The parameters of the jumper cables must be appropriate to the current consumed by the battery starter. 200A jumper cables are intended for starting engines with a capacity of up to 900 ccm.

400A jumper cables are intended for starting engines with a capacity of up to 1400 ccm.

Jumper cables 600A are intended for starting engines with a capacity of up to 2000 ccm.

Cables 600 - 1800A should be used to start diesel engines.