Strong wires, jumper cables 300a 3m 12 24v

Jumper cables 12/24V 3m 300A with cover SKRAW-MET CODE: [3049] Jumper cables are designed to support starting a vehicle with a discharged battery using electricity taken from the battery of another vehicle.

Very useful in the basic equipment of the car - especially in winter, when low temperatures make it easier for the battery to discharge.

A bundle with a thick weave made of the highest quality copper-plated wires. Copper-plated clamps, which ensures:

very good current flow,

effective and quick starting of the engine,

no overheating of the wires

efficiency in extremely low temperatures

Technical specifications: Maximum current: 300 A

Cable length with clamps: 3 m

Cable diameter: 7 mm

Frag length: 140 mm

Frog clamp stroke: 25 mm

Resistant to very low and high temperatures: -70°C to +160°C

Material: Cables: copper-plated

Clamps: copper-plated

Strong clamps enable safe use of cables in the most difficult conditions.

Cables packed in a practical cover to protect against dirt.After on the other side of the cover there is an instruction manual, which makes it easier to start a disabled car with a discharged battery.

In our other auctions you will also find cables with other lengths and maximum current intensities. The parameters of the jumper cables must be appropriate to the current consumed by the battery starter.200A jumper cables are intended for starting engines with a capacity of up to 900 ccm.

400A jumper cables are intended for starting engines with a capacity of up to 1400 ccm.

600A jumper cables are intended for for starting engines with a capacity of up to 2000 cc.

Cables 600 - 1800A should be used to start diesel engines.