Strong wires, jumper cables 400a 2m 12 24v

Jumper cables 12/24V 2m 400A with cover SKRAW-MET CODE: [3050] Jumper cables are designed to support starting a vehicle with a discharged battery using electricity taken from the battery of another vehicle.

Very useful in the basic equipment of a car - especially in winter, when low temperatures make it easier for the battery to discharge.

A bundle with a thick weave made of the highest quality copper-plated wires. Copper-plated clamps, which ensures:

very good current flow,

effective and quick starting of the engine,

no overheating of the wires

efficiency in extremely low temperatures

Technical specifications: Maximum current: 400 A

Cable length with clamps: 2 m

Cable diameter: 7.5 mm

Length of clamps: 140 mm

Clip clamp stroke: 25 mm

Resistant to very low and high temperatures: -70°C to +160°C

Material: Cables: copper-plated

Clamps: copper-plated

Strong clamps enable safe use of cables in the most difficult conditions.

Cables packed in a practical cover to protect against dirt .On the other side of the cover there is an instruction manual, which makes it easier to start a disabled car with a discharged battery.

You can also find cables of other lengths and maximum currents in our other auctions. The parameters of the jumper cables must be appropriate to the current. drawn by the battery starter.200A jumper cables are intended for starting engines with a capacity of up to 900 cc.

400A jumper cables are intended for starting engines with a capacity of up to 1400 cc.

600A jumper cables are intended for starting engines with a capacity of up to 2000 cc.

Cables 600 - 1800A should be used to start diesel engines.