3x universal remote control 433 mhz with relay

3x4 433M 5V Wireless RF Receiver Learning Board Remote Control

Description:

4 channel wireless receiver can learn 433M remote control, such as 2260, 2262, 2264 and EV1527 etc.

VCC: Connect to the positive pole of power supply, GND: Connect to the negative pole of power supply

Maximum output current: 10MA(each channel), Quiescent working current: 3mA

Working frequency: 433MHz(4 channels, each channel can learn independently)

Receiving distance: 10-35m(can through the wall), Working voltage: 4.5-5.5(input end)

Working mode: self-locking, jog, interlock

Working indicator: (learning indicator and signal receiving indicator)

Output level: The output high level is equal to or slightly lower than the VCC voltage

Application: All devices and systems powered by 5V high or low level signals

Receiver Size: Approx. 26 x 23 x 12mm/1 x 0.9 x 0.5in

Specification:

1. Learning Method

A. After power on, press and hold the learning button, the learning indicator flashes once, release the button, and then press and hold the remote control button that needs to be learned, the learning indicator does not flash after flashing 3 times, and the learning of the first channel is completed. Similarly, the corresponding learning of other channels, when the learning indicator flashes 2, 3 and 4 times, indicates that the learning of the second, third and fourth channels is completed

Method: in the state, press and hold the learning button, and then turn on the power, after the learning indicator flashes 4 times, release the button, indicating that the module has been successfully cleared

2. Self-lock, Jog and Interlock Function Conversion Operation

Interlock: In the state, press and hold the learning button and turn on the power, the learning indicator flashes once, then release the button. The interlock output setting is completed. (Press the remote control button, the corresponding channel of the module has output, other channels are closed, no output)

Self-lock: Similarly, the learning indicator flashes twice, which indicates that the self-locking set is completed (the corresponding channel of the module output will not affect other channels, release the remote control, maintain the output state)

Jog: After power off, hold the learning button, then turn on the power. The learning indicator flashes 3 times, release the button, then set the jog output. (the corresponding channel of the module has output, release the remote control and stops output)

Package includes: (3 packs)

1 piece receiver (with antenna)

1 piece remote control